PRIMEQUEST 1000 Series Tool Reference
CHAPTER 2 MMB CLI (Command Line Interface) Operations
The specified date is invalid.
Unable to set date because NTP is enabled.
Time synchronization was requested to Standby MMB.
Unable to execute this command on a standby MMB.
2.2.12
set gateway
The set gateway command sets the default gateway.
The default setting value is 0.0.0.0.
Privileges: Administrator
(1) Syntax
set gateway <ip address>
(2) Options
None
(3) Usage example
None
(4) Messages
The following messages appear for this CLI command.
For details on the messages, see the PRIMEQUEST 1000 Series Message Reference (C122-E111EN).
The specified gateway address is invalid.
The specified parameter is invalid.
The specified IP address is duplicated.
The specified IP address is loopback address.
Unable to execute this command on a standby MMB.
2.2.13
set gateway_ipv6
The set gateway_ipv6 command sets the IPv6 default gateway.
To automatically set an address, set "auto" in the options.
Privileges: Administrator
(1) Syntax
- Manual setting
set gateway_ipv6 <ip address>
238
C122-E110-10EN