Checking The Physical Partition (Ppar) Status; Synchronizing The Physical Partition (Ppar) Time And Xscf Time - Fujitsu SPARC M12-1 Installation Manual

6.8 Checking the Physical Partition
(PPAR) Status
For the SPARC M12-1, the system board (PSB) is assigned in advance to a logical
system board (LSB) of a physical partition (PPAR).
Execute the showboards command to check the system board (PSB) status.
1.
XSCF> showboards -a
PSB
---- ------------ ----------- ---- ---- ---- ------- --------
00-0 00(00)
XSCF>
6.9 Synchronizing the Physical Partition
(PPAR) Time and XSCF Time
This section describes the procedure for clearing the difference between the XSCF
time, which is the system time, and the physical partition (PPAR) time.
The XSCF keeps the time difference from the physical partition. With each change by
the setdate command to the system time, the difference is updated with the
difference between the physical partition time and the changed system time.
1. Execute the showdate command to display the XSCF time.
If you have set the time zone, the command displays the local time.
The following example displays the current time in the local time zone.
XSCF> showdate
Sat Oct 20 14:53:00 JST 2012
2. Confirm that the set XSCF time is correct. To change the date and time,
execute the setdate command.
For details, see
3. Execute the showdateoffset command to check the times difference between
the XSCF system time and physical partition time.
The following example displays the difference between the system time and the
time of PPAR-ID 0.
100 Fujitsu SPARC M12-1 Installation Guide ･ June 2021
PPAR-ID(LSB) Assignment
Assigned
"5.6 Setting the
Pwr Conn Conf Test
n n n Passed
Time."
Fault
Normal