Set Ssh - Fujitsu PRIMEQUEST 1000 Series Tool Reference

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 2 MMB CLI (Command Line Interface) Operations
Example: Setting "hogehoge" as the name for partition 3
# set partition name 3 hogehoge
#
(4) Messages
The following messages appear for this CLI command.
For details on the messages, see the PRIMEQUEST 1000 Series Message Reference (C122-E111EN).
The specified partition number is invalid.
The specified partition name is invalid.
Partition#x is not defined.
Unable to execute this command on a standby MMB.
The specified parameter is invalid.
Unable to execute this command because the system is under maintenance.
Unable to execute this command because the Partition#x is under maintenance.
Succeed to set partition name command.
Failed to execute set partition name command.
Failed to execute %s command.
The specified command is not supported.(error=[%s])
2.2.25

set ssh

The set ssh command enables or disables SSH.
The default setting is disable (SSH disabled).
Privileges: Administrator
(1) Syntax
set ssh [enable | disable]
(2) Options
None
(3) Usage example
None
(4) Messages
The following messages appear for this CLI command.
For details on the messages, see the PRIMEQUEST 1000 Series Message Reference (C122-E111EN).
Unable to execute this command on a standby MMB.
248 C122-E110-10EN