Basic Operations With The Cli; Access To The Cli Via The Serial Interface; Access Via The Management Lan Interface; Cli Command List - Fujitsu PRIMEQUEST 1000 Series Tool Reference

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 2 MMB CLI (Command Line Interface) Operations
2.1

Basic Operations with the CLI

You can access the CLI in the following two ways:
- Access via the serial port on the MMB
- Access via the management LAN of the MMB from a remote PC
Remarks
Similar to the GUI, the CLI also enables up to 16 users to log in to the CLI concurrently.
2.1.1

Access to the CLI via the serial interface

You can access the CLI of the MMB via the serial interface by using the following procedure.
1. Connect your terminal (e.g., laptop PC) to the MMB with an RS-232C crossover cable.
2. Start the terminal software (e.g., Windows HyperTerminal) on the terminal. Then, configure the terminal
software as follows.

TABLE 2.1 Terminal software setting values

Parameter
Bits/second
Data bits
Parity
Stop bits
Flow control
Emulation
3. The login prompt appears. Enter your user name and password to log in.
2.1.2

Access via the management LAN interface

You can access the CLI of the MMB via the management LAN interface by using the following procedure.
1. Connect a remote PC to the MMB with a straight LAN cable.
2. Start the telnet or SSH client on the remote PC. Establish a connection between the remote PC and the MMB
by specifying the IP address (IPv4 or IPv6) of the MMB and the telnet port number or SSH port number.
3. Enter the account and password to log in.
Remarks
The MMB provides connection features that work only with the SSH V2 protocol.
This means you need to be running SSH V2-compatible terminal software to connect the MMB.
2.1.3

CLI command list

This section describes the functions of the CLI commands.
- Setting commands
Value
19200
8
None
1
None
VT100
212 C122-E110-10EN