Table 1.103 Buttons In The [Snmp Trap] Window - Fujitsu PRIMEQUEST 1000 Series Tool Reference

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 1 MMB Web-UI (Web User Interface) Operations
Item
Priv passphrase Sets a passphrase for encryption.
This item takes effect only if [3] is selected for [SNMP Version] and [priv] is selected
for [Auth].

TABLE 1.103 Buttons in the [SNMP Trap] window

Button
Apply
Cancel
Test Trap
(1) Menu operations
[Network Configuration] - [SNMP Configuration] - [SNMP Trap]
(2) Window operations
- Configuring SNMP trap information
1. Enter the community or user name, the IP address of a trap destination, the SNMP version, and the
authentication level. Then, click the [Apply] button.
This sets the entered information.
- Sending a test trap
1. Click the [Test Trap] button.
This sends a test trap.
Messages
The following table lists the messages displayed in this window.
Message number
I_00013
For details on messages displayed in the window, see the PRIMEQUEST 1000 Series Message Reference (C122-
E111EN).
[SNMP v3 Configuration] window
You can set a unique Engine ID and users for SNMP v3 in the [SNMP v3 Configuration] window.
You can register a maximum of 16 users for SNMP v3. The window displays the user names of registered users.
Remarks
If you change the Engine ID or IP address, you need to reconfigure all the settings for the users set for SNMP v3
access.
The changes for the specified users take effect only after the SNMP Service is stopped and restarted. For this reason,
clicking the [Apply] button temporarily stops SNMP Service and then automatically restarts it.
Sets the specified information.
Restores the original information and does not set the specified information,
such as the community or user name, and the IP address of a trap destination.
Sends a test trap to the specified trap destination.
Setting completed.
Description
Description
Message text
181 C122-E110-10EN