Schedule] Menu - Fujitsu PRIMEQUEST 1000 Series Tool Reference

PRIMEQUEST 1000 Series Tool Reference
CHAPTER 1 MMB Web-UI (Web User Interface) Operations
Message number
I_00222
E_00422
E_00154
E_00482
E_00491
E_00504
E_00517
E_00522
For details on messages displayed in the window, see the PRIMEQUEST 1000 Series Message Reference (C122-
E111EN).
1.3.2

[Schedule] menu

The [Schedule] menu has the [Schedule Control] window and [Schedule List] window. This section describes these
windows and their operations.
Note
The times recorded in the SEL may lag behind the scheduled operation times as described below.
- After a configuration check and preparation for startup, the power-on sequence may take a while to start. In
such cases, the displayed SEL times may be six to eight seconds later than the scheduled operation times.
- The shutdown instruction from the MMB to the operating system is executed within a few seconds after the
set time. However, the following times may vary depending on the setting, configuration, etc.:
- The time that the instruction from the MMB takes to reach the operating system
- The time from the start of the operating system shutdown to MMB notification of the shutdown start
in the SEL
- Even if the [Power on Delay] setting is 0 seconds, the period from the start of the power-on sequence to a
reset may still range from 30 to 70 seconds.
[Schedule Control] window
You can make settings related to the schedule for each partition in the [Schedule Control] window.
Unable to %aa the Partition#%aa because this Partition is under maintenance.
Unable to power on the partition#%aa due to CPU composition abnormal.
Unable to power on due to mismatch between supply voltage and input voltage.
Unable to power on the partition#%aa due to DIMM composition abnormal.
Unable to power on the partition#%aa due to DIMM does not satisfy requirements of
Mirror Mode.
The Power On failed, because of switching the Home SB.
Please execute it after a while again.
Unable to power on the partition#%d due to abnormal SB composition.
Unable to power on the partition#%d due to abnormal VRM composition.
Message text
122 C122-E110-10EN