Executing An Snmp Trap Test - Fujitsu ETERNUS LT160 User Manual

Remote Panel Operation
5.6.5

Executing an SNMP trap test

After setting up SNMP, a trap test can be executed to check that a trap is transmitted to
the device with the specified IP address.
1) Click the [SNMP] button displayed under [Operation] to display the following
2) To start the trap test, click [OK].
3) After transmission is completed, the following window is displayed. Verify that the
5-50
1. If an attempt is made to restore a file that has not been saved, an
error message is displayed. Specify a correct file.
2. If Netscape Navigator is used, do not use kana or kanji in the
name of a directory that containing a restoration file.
window.
Figure 5.37 SNMP trap test start window
trap is transmitted to the device having the specified destination IP address.
Remarks:
C144-E072-01EN