10.6.6
SNMP Trap Commands
10.6.6.1
show snmptrap
This command displays SNMP trap receivers. Trap messages are sent across a network to an SNMP
Network Manager. These messages alert the manager to events occurring within the switch or on the
network. Six trap receivers are simultaneously supported.
Syntax
show snmptrap
Default Setting
None
Command Mode
Privileged Exec
Display Message
SNMP Trap Name: The community string of the SNMP trap packet sent to the trap manager. This
may be up to 64 alphanumeric characters. This string is case sensitive.
IP Address: The IPv4 or IPv6 address to receive SNMP traps from this device.
SNMP Version: The trap version to be used by the receiver.
SNMP v1 - Uses SNMP v1 to send traps to the receiver
SNMP v2 - Uses SNMP v2 to send traps to the receiver
SNMP v3 - Uses SNMP v3 to send traps to the receiver
Status: A pull down menu that indicates the receiver's status (enabled or disabled) and allows the
administrator/user to perform actions on this user entry:
Enable - send traps to the receiver
Disable - do not send traps to the receiver.
2011 Fujitsu Technology Solutions
©
536