Show Rdr-Formatter; Show Interface Linecard Subscriber Sm-Connection-Failure - Cisco SCE 8000 Installation And Configuration Manual

Appendix B CLI Commands to Verify a Successful Installation

show RDR-formatter

Look for:
•
•
SCE8000> show RDR-formatter
Status:
Connection is: up
Forwarding mode: redundancy
Connection Table:
--------------------------------------------------------------------------------
| Collector
| IP-Address
| Host-Name
|---------------|-------|------|-----------|------------|-----------|-----------|
| 10.240.59.39
| 10.240.59.44
---------------------------------------------------------------------------------
RDR:
UM:
Logger: queued:
Errors: thrown:
Last time these counters were cleared: 07:36:52

show interface linecard subscriber sm-connection-failure

If working with the Subscriber Manager, use this command to make sure the connection with the SM is
established:
SCE8000> show interface linecard 0 subscriber sm-connection-failure
Current SM link state: up.
Configured action to take when SM link is down: No action.
Changing of system operational-status to 'warning' when SM link is down: enabled.
Forwarding mode
Status (in Status column in the Connection Table)
enabled
| Port |Status| Priority per Category:
/ | |
| |
| 33000 | up
| 33000 | up
queued: 0 ,sent:60108106, thrown:
queued: 0 ,sent:
0 ,sent:
0
|------------------------------------------------|
| Category1 | Category2
|100 primary| ---
| --- |100 primary | ---
0, format-mismatch:
0, thrown: 0
0, thrown: 0
EDT
Cisco SCE8000 GBE Installation and Configuration Guide
CLI Command Output Samples
| Category3 | Category4 |
| --- | ---
| ---
0
TUE April 28 2009
|
|
|
B-9