Install And Remove Transceiver Modules - Cisco CQ211L01-48H8FH Hardware Installation Manual

Install and Remove Transceiver Modules

Install and Remove Transceiver Modules
Install and Remove QSFP Transceiver Modules
This section provides the installation, cabling, and removal instructions for the Quad Small Form-Factor
Pluggable transceiver modules. Refer to the
on optical transceivers.
The following figure shows a 400-Gigabit QSFP-DD optical transceiver.
Figure 13: 400-Gigabit QSFP-DD Transceiver Module
1
3
Warning
Statement 1079—Hot Surface
This icon is a hot surface warning. Use precaution when working near the hot surface.
Required Tools and Equipment
You need these tools to install the transceiver modules:
• Wrist strap or other personal grounding device to prevent ESD occurrences.
• Antistatic mat or antistatic foam to set the transceiver on.
Pull-tab
Electrical connection to the module circuitry
Cisco Optical Transceiver Handling Guide
2
Hardware Installation Guide for Cisco CQ211L01 Switch
Connect Router to the Network
for additional details
QSFP-DD transceiver body
33