Dot1X Timeout Supp-Timeout - Dell N1100-ON Reference Manual

dot1x timeout supp-timeout

Use the dot1x timeout supp-timeout command to set the time that the
switch waits for a response before retransmitting an Extensible
Authentication Protocol (EAP-Request/Identity) frame to the client. To
return to the default setting, use the no form of this command.
Syntax
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
• seconds—The time in seconds that the switch should wait for a response
to an EAP-request frame from the client before resending the request.
(Range: 1–65535)
Default Configuration
The default supplicant timeout is 30 seconds.
Command Mode
Interface Configuration mode
User Guidelines
Change the value of the supplicant timeout only to adjust for unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers. The default timeout value is set
per IEEE 802.1x.
This value is used in conjunction with the dot1x timeout server-timeout
command to limit the amount of time a supplicant can remain in a pending
authentication state.
Example
console(config-if-Gi1/0/1)#dot1x timeout supp-timeout 60
Security Commands
967