[26-63] Interface-Desc; [26-81] L2C-Information; [26-92] L2C-Up-Stream-Data - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

JUNOSe 11.1.x Broadband Access Configuration Guide

[26-63] Interface-Desc

Use the following command to manage the Interface-Desc RADIUS attribute.
radius include interface-description

[26-81] L2C-Information

Use the following command to manage the L2C-Information RADIUS attribute.
radius include access-loop-parameters

[26-92] L2C-Up-Stream-Data

Use the following command to manage the L2C-Up-Stream-Data RADIUS attribute.
radius include l2c-upstream-data
230
CLI Commands Used to Modify RADIUS Attributes
radius include interface-description
Use to include the Interface-Desc attribute, with the subscriber's access interface
description, in Access-Request, Acct-Start, Interim-Acct, or Acct-Stop messages.
You can control inclusion of the Interface-Desc attribute by enabling or disabling
this command. Inclusion is disabled by default.
There is no explicit command to include the Interface-Desc attribute in
Interim-Acct messages; however, the attribute is automatically included in
Interim-Acct messages when the attribute is enabled for Acct-Stop messages.
See radius include
Example
host1(config)#radius include interface-description acct-start enable
Use the no version to restore the default, disable.
radius include access-loop-parameters
Use to include the L2C-Information attribute in Access-Request messages.
You can control inclusion of the L2C-Information attribute by enabling or disabling
this command. Inclusion is disabled by default.
See radius include
Example
host1(config)#radius include access-loop-parameters access-request enable
Use the no version to restore the default, disable.
radius include l2c-upstream-data