Juniper Networks Vendor-Specific Attributes; Virtual-Router; Ingress-Policy-Name - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide
radius include tunnel-server-attributes

Juniper Networks Vendor-Specific Attributes

This section describes the Juniper Networks vendor-specific attributes (VSAs) that
you can configure using CLI commands. The attributes are listed numerically and
are followed by descriptions about the commands that you can use to manage the
attribute.

[26-1] Virtual-Router

Use the following command to manage the Virtual-Router RADIUS attribute.
radius ignore virtual-router

[26-10] Ingress-Policy-Name

Use the following commands to manage the Ingress-Policy-Name RADIUS attribute.
214
CLI Commands Used to Modify RADIUS Attributes
radius include tunnel-server-attributes
Use to include all supported tunnel server attributes in Access-Request, Acct-Start,
or Acct-Stop messages.
When the router functions as an LNS with a terminating PPP, then the LAC tunnel
attributes are included.
You can control inclusion of all tunnel server attributes by enabling or disabling
this command.
See radius include
Example
host1(config)#radius include tunnel-server-attributes access-request enable
Use the no version to restore the default, disable.
radius ignore virtual-router
Use to cause the Virtual-Router attribute to be ignored in Access-Accept messages.
You can control this behavior by enabling or disabling this command.
See radius ignore
Example
host1(config)#radius ignore virtual-router enable
Use the no version to restore the default, disable.
radius include ingress-policy-name
radius ignore ingress-policy-name