Table of Contents
Advertisement
1. Shut down the engine, and remove the key from
the ignition.
2. Remove the hairpin from clevis pin (B) on draper header
support (A). Remove clevis pin (B).
3. Position draper header support (B) on windrower lift
linkage (A). Reinstall clevis pin (C).
NOTE:
To ensure that the pin doesn't snag the windrow, install the
clevis pin on the outboard side of the draper header
support.
4. Secure clevis pin (C) with hairpin (D).
5. Repeat Step
2, page 140
remaining draper header support.
5.3.2 Attaching D1X and D1XL Series Draper Headers
The windrower's lift linkage and center-link will need to be connected to the draper header.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator's seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Ensure that all bystanders have cleared the area.
1. Clear all bystanders from the area.
2. Shut down the engine, and remove the key from the ignition.
262175
ATTACHING HEADERS TO WINDROWER
to Step
4, page 140
to install the
Figure 5.95: Draper Header Support
D
C
Figure 5.96: Draper Header Support
140
A
A
B
B
Revision A
Advertisement
Table of Contents
