Table of Contents
Advertisement
Serial port
n
n
n
n
c. Expand Logging Settings to configure logging for this serial port.
a. To enable logging, click to toggle on Enable.
b. For Log File Size, type the size of the log file. When the log file reaches the size limit,
the current file is saved and a new file is created.
The log file is saved to the /opt/serial directory. Because this is being save to the device's
memory, you should use serial logging for diagnostic purposes, rather than having it
permanently enabled.
10. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
IX30 User Guide
To limit access to specified IPv4 addresses and networks:
i. Click IPv4 Addresses.
ii. For Add Address, click .
iii. For Address, enter the IPv4 address or network that can access the device's
service-type. Allowed values are:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the service-type.
l
iv. Click again to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
i. Click IPv6 Addresses.
ii. For Add Address, click .
iii. For Address, enter the IPv6 address or network that can access the device's
service-type. Allowed values are:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the service-type.
l
iv. Click again to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the IX30 device:
i. Click Interfaces.
ii. For Add Interface, click .
iii. For Interface, select the appropriate interface from the dropdown.
iv. Click again to allow access through additional interfaces.
To limit access based on firewall zones:
i. Click Zones.
ii. For Add Zone, click .
iii. For Zone, select the appropriate firewall zone from the dropdown.
See
Firewall configuration
iv. Click again to allow access through additional firewall zones.
for information about firewall zones.
Configure UDP serial mode
242
Advertisement
Table of Contents
