Digi IX30 User Manual page 466

Virtual Private Networks (VPN)
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured L2TP access connectors, type the following at the
prompt:
> show l2tp lac
Name
---------
lac_test1
lac_test2
>
3. To display details about a specific tunnel:
> show l2tp lac name lac_test2
lac_test2 L2TP Access Concentrator Status
------------------------------------
Enabled
Status
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show the status of L2TP network servers from the Admin CLI
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured L2TP access connectors, type the following at the
prompt:
> show l2tp lns
Name
---------
lns_test1
lns_test2
>
3. To display details about a specific tunnel:
> show l2tp lns name lns_test2
lns_test2 L2TP Access Concentrator Status
IX30 User Guide
Enabled Status Device
------- ------ -----------
true up test_device0
true pending
: true
: pending
Enabled Status Device
------- ------ -----------
true up test_device0
true pending
L2TP
466