Table of Contents
Advertisement
Containers
iv. (Optional) Select the Device Type and Firmware Version that applies to the
v. Click Upload.
vi. Repeat to upload additional containers.
ii. Select one or more containers to add to the configuration.
iii. Click Done.
iv. Click Save.
v. Click Continue.
c. For the Automation step:
i. Click to toggle on Enable Scanning.
ii. Click to toggle on Remediate.
2.
Run a manual configuration scan
applicable devices.
3. Verify that the container is running on a device:
To verify by using device metrics:
n
a. From the Remote Manager main menu, click Management > Devices.
b. Click the Device ID to open the device's Details page..
c. Click Metrics.
d. Information about configured containers is located under the Container Details
To verify by using the Data streams page:
n
a. From the Remote Manager main menu, click Management > Data Streams.
b. Locate the container's data stream:
IX30 User Guide
container.
If set, these options will limit the container to only be included in Configuration
templates that match the specified device type and firmware version. If these are
left blank, the container can be included in any Configuration template.
to apply the container and configuration settings to all
heading.
to search using advance filtering.
i. Click
ii. Click in the search text bar and select Device ID from the menu.
Use Digi Remote Manager to deploy and run containers
807
Advertisement
Table of Contents
