Table of Contents
Advertisement
Services
a. Click to expand On entry.
b. (Optional) Enable Bootup action to configure the device to perform the On entry
c. For Number of intervals, type or select the number of
d. Click to expand Actions.
e. Click to create a new action.
f. For Action type, select either:
To define actions that will be taken when the device exits the geofence, or is outside the
n
geofence when it boots:
IX30 User Guide
actions if the device is inside the geofence when it boots.
take place prior to performing the On entry actions.
For example, if the Update interval is 1m (one minute) and the Number of
intervals is 3, the On entry actions will not be performed until the device has been
inside the geofence for three minutes.
Factory erase to erase the device configuration when the action is triggered.
l
Custom script to execute a custom script when the action is triggered.
l
If Custom script is selected:
i. Click to expand Custom script.
ii. For Commands, type the script that will be executed when the action is
triggered. If the script begins with #!, then the proceeding file path will be used
to invoke the script interpreter. If not, then the default shell will be used.
iii. Enable Log script output to log the output of the script to the
iv. Enable Log script errors to log errors from the script to the
v. (Optional) For Maximum memory, type the maximum amount of system
memory that will be available for the script and it spawned processes.
Allowed values are any integer followed by one of the following:
b|bytes|KB|k|MB|M|GB|G|TB|T.
For example. the allocate one megabyte of memory to the script and its
spawned processes, type 1MB or 1M.
vi. Sandbox is enabled by default. This prevents the script from adversely
affecting the system. If you disable Sandbox, the script may render the system
unusable.
vii. Repeat for any additional actions.
Location information
Update Intervals
that must
system
log.
system
log.
551
Advertisement
Table of Contents
