Example: Domain-Based Routing With Dual Wan - Digi IX30 User Manual

Routing
c. Set the interface:
(config network route policy 0)> interface /network/interface/
(config network route policy 0)>
d. Configure the source address:
i. Set the source type to zone:
(config network route policy 0)> src type zone
(config network route policy 0)>
ii. Set the zone to internal:
(config network route policy 0)> src zone internal
(config network route policy 0)>
e. Configure the destination address:
i. Set the destination to use an IPv4 address:
(config network route policy 0)> dst type address
(config network route policy 0)>
ii. Set the IP address that will be the destination for outgoing traffic routed through the
WWAN interface. In the above example, this is 241.236.162.59.
(config network route policy 0)> dst address 241.236.162.59
(config network route policy 0)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Example: Domain-based routing with dual WAN

This example routes traffic destined for a specific domain to the WAN Ethernet port, and never
through the cellular modem.

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
IX30 User Guide
IP routing
292