Table of Contents
Advertisement
Serial port
4. For Electrical signalling mode, select RS-232.
5. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the signalling mode to rs-232:
(config)> serial port1 signal_mode rs-232
(config)>
If this is the end device along a cabled RS-485 daisy chain and termination resistors are
recommended, enable an internal electrical termination:
(config)> serial port1 termination true
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Change the electrical signalling mode to RS-422
To change the signalling mode:
Web
IX30 User Guide
Electrical Signalling Mode
261
Advertisement
Table of Contents
