Table of Contents
Advertisement
User authentication
Admin access
n
For groups assigned Admin access, you can also determine whether the Access level
should be Full access or Read-only access.
l
l
The default is Full access.
Serial access
n
Interactive shell access
n
Shell access is not available if the Allow shell parameter has been disabled. See
shell access
6. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
IX30 User Guide
Full access provides users of this group with the ability to manage the IX30 device
by using the WebUI or the Admin CLI.
Read-only access provides users of this group with read-only access to the WebUI
and Admin CLI.
for more information about the Allow shell parameter.
Authentication groups
Disable
702
Advertisement
Table of Contents
