Table of Contents
Advertisement
User authentication
12. Add an LDAP server:
a. Add the server:
(config)> add auth ldap server end
(config auth ldap server 0)>
b. Enter the LDAP server's IP address or hostname:
(config auth ldap server 0)> hostname hostname|ip-address
(config auth ldap server 0)>
c. (Optional) Change the default port setting to the appropriate port:
(config auth ldap server 0)> port port
(config auth ldap server 0)>
d. (Optional) Repeat the above steps to add additional LDAP servers.
13. Add LDAP to the authentication methods. Authentication methods are attempted in the order
they are listed until the first successful authentication result is returned. This example will add
LDAP to the end of the list. See
methods to the beginning or middle of the list.
(config)> add auth method end ldap
(config)>
14. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
15. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure serial authentication
This section describes how to configure authentication for serial access.
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
IX30 User Guide
User authentication methods
Use Digi Remote Manager to view and manage your
Configure serial authentication
for information about adding
743
Advertisement
Table of Contents
