Digi IX30 User Manual page 130

Interfaces
d. See Configure SureLink active recovery to detect WAN/WWAN failures
about configuring SureLink.
10. (Optional) Configure IPv6 settings:
a. Click to expand IPv6.
b. Enable IPv6 support.
c. For Type, select DHCPv6 address.
d. For Prefix length, type the minimum length of the prefix to assign to this LAN. If the
minimum length is not available, then a longer prefix will be used.
e. For Prefix ID, type the identifier used to extend the prefix to the assigned length. Leave
blank to use a random identifier.
f. Set the Metric.
See Configure WAN/WWAN priority and default route metrics
metrics.
g. For Weight, type the relative weight for default routes associated with this interface. For
multiple active interfaces with the same metric, Weight is used to load balance traffic to
the interfaces.
h. Set the Management priority. This determines which interface will have priority for
central management activity. The interface with the highest number will be used.
i. Set the MTU.
j. For Use DNS:
n
n
n
k. Enable DHCP Hostname to instruct the IX30 device to include the device's system name
with DHCP requests as the Client FQDN option. The DHCP server can then be configured to
register the device's hostname and IP address with an associated DNS server.
n
n
11. (Optional) Click to expand MAC address denylist.
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address denylist.
a. Click to expand MAC address denylist.
b. For Add MAC address, click .
c. Type the MAC address.
IX30 User Guide
See RFC4702 for further information about DHCP server support for the Client
n
FQDN option.
See Configure system information
n
device's system name.
Always: DNS will always be used for this WAN; when multiple interfaces have the
same DNS server, the interface with the lowest metric will be used for DNS
requests.
When primary default route: Only use the DNS servers provided for this interface
when the interface is the primary route.
Never: Never use DNS servers for this interface.
See RFC4702 for further information about DHCP server support for the Client
FQDN option.
See Configure system information
system name.
Wide Area Networks (WANs)
for information about setting the IX30
for further information about
for information about setting the IX30 device's
for information
130