Table of Contents
Advertisement
User authentication
4. For Add Method, click .
5. Select the appropriate authentication type for the new method from the Method drop-down.
Note
Authentication methods are attempted in the order they are listed until the first
successful authentication result is returned. See
methods
for information about how to reorder the authentication methods.
6. Repeat these steps to add additional methods.
7. Click Apply to save the configuration and apply the change.
Command line
Authentication methods are attempted in the order they are listed until the first successful
authentication result is returned. This procedure describes how to add methods to various places in
the list.
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add the new authentication method to the appropriate location in the list:
To determine the current list of authentication methods:
n
a. Select the device in Remote Manager and click Actions > Open Console, or log into
b. At the command line, type config to enter configuration mode:
c. Use the show auth method command to display the current authentication
IX30 User Guide
the IX30 local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access
selection menu. Type admin to access the Admin CLI.
> config
(config)>
methods configuration:
User authentication methods
Rearrange the position of authentication
695
Advertisement
Table of Contents
