Digi IX30 User Manual page 789

Firewall
New QoS binding policy rules are enabled by default. To disable, toggle off Enable.
iii. (Optional) Type a Label for the binding policy rule.
iv. For Type Of Service, type the value of the Type of Service (ToS) packet header that
defines packet priority. If unspecified, this field is ignored.
See
v. For Protocol, select the IP protocol matching criteria for this rule.
vi. For Source port, type the port, or any, as a source traffic matching criteria.
vii. For Destination port, type the port, or any, as a destination traffic matching criteria.
viii. Click to expand Source address and select the Type:
ix. Click to expand Destination address and select the Type:
Repeat to add a new rule. Up to 30 rules can be configured.
10. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
IX30 User Guide
https://www.tucny.com/Home/dscp-tos
Any: Source traffic from any address will be matched.
n
Interface: Only traffic from the selected Interface will be matched.
n
IPv4 address: Only traffic from the IP address typed in IPv4 address will be
n
matched. Use the format IPv4_address[/netmask], or use any to match any
IPv4 address.
IPv6 address: Only traffic from the IP address typed in IPv6 address will be
n
matched. Use the format IPv6_address[/prefix_length], or use any to match
any IPv6 address.
MAC address: Only traffic from the MAC address typed in MAC address will be
n
matched.
Any: Traffic destined for anywhere will be matched.
n
Interface: Only traffic destined for the selected Interface will be matched.
n
IPv4 address: Only traffic destined for the IP address typed in IPv4 address
n
will be matched. Use the format IPv4_address[/netmask], or use any to match
any IPv4 address.
IPv6 address: Only traffic destined for the IP address typed in IPv6 address
n
will be matched. Use the format IPv6_address[/prefix_length], or use any to
match any IPv6 address.
Configure Quality of Service options
for a list of common TOS values.
789