Configure A Routing Policy - Digi IX30 User Manual

Routing

Configure a routing policy

Required configuration items
The packet matching parameters. It can any combination of the following:
n
Source interface.
l
Source address. This can be a firewall zone, an interface, a single IPv4/IPv6 address or
l
network, or a MAC address.
Destination address. This can be a firewall zone, an interface, a single IPv4/IPv6 address or
l
network, or a domain.
Protocol. This can be any, tcp, udp or icmp.
l
Source port. This is only used if the protocol is set to tcp or udp.
l
Destination port. This is only used if protocol is set to tcp or udp.
l
The network interface used to reach the destination.
n
Additional configuration items
A label for the routing policy.
n
Whether packets that match this policy should be dropped when the gateway interface is
n
disconnected, rather than forwarded through other interfaces.
To configure a routing policy:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX30 User Guide
Use Digi Remote Manager to view and manage your
IP routing
282