Table of Contents
Advertisement
User authentication
7. (Optional) For NAS ID, type the unique identifier for this network access server (NAS). You can
use the fully-qualified domain name of the NAS or any arbitrary string. If not set, the default
value is used:
If you are accessing the IX30 device by using the WebUI, the default value is for NAS ID is
n
httpd.
If you are accessing the IX30 device by using ssh, the default value is sshd.
n
8. Add RADIUS to the authentication methods:
a. Click Authentication > Methods.
b. For Add method, click .
c. Select RADIUS for the new method from the Method drop-down.
Authentication methods are attempted in the order they are listed until an authentication
response, either pass or fail, is received. If Authoritative is enabled (see above), non-
authoritative methods are not attempted. See
methods
for information about rearranging the position of the methods in the list.
9. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) Prevent other authentication methods from being used if RADIUS authentication
fails. Other authentication methods will only be used if the RADIUS server is unavailable.
(config)> auth radius authoritative true
(config)>
4. (Optional) Enable debug messages from the RADIUS client:
(config)> auth radius debug true
(config)>
IX30 User Guide
Remote Authentication Dial-In User Service (RADIUS)
Rearrange the position of authentication
734
Advertisement
Table of Contents
