Digi IX30 User Manual page 192

Interfaces
g. For Use DNS, select one of the following:
n
n
n
h. See Configure SureLink active recovery to detect WAN/WWAN failures
about configuring SureLink for active recovery.
17. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new interface or edit an existing one:
To create a new interface named ip_passthrough_interface:
n
(config)> add network interface ip_passthrough_interface
(config network interface ip_passthrough_interface)>
To edit an existing interface named ip_passthrough_interface, change to the IP-
n
passthrough-interface node in the configuration schema:
(config)> network interface ip_passthrough_interface
(config network interface ip_passthrough_interface)>
4. Set the interface type to passthrough:
(config network interface ip_passthrough_interface)> type passthrough
(config network interface ip_passthrough_interface)>
5. Set the firewall zone to internal:
(config network interface ip_passthrough_interface)> zone internal
(config network interface ip_passthrough_interface)>
6. Select an Ethernet device or a Wi-Fi access point for this interface:
a. Enter device ? to view available devices and the proper syntax.
(config network interface my_wan)> device ?
IX30 User Guide
Always: DNS will always be used for this WAN; when multiple interfaces have the
same DNS server, the interface with the lowest metric will be used for DNS
requests.
When primary default route: Only use the DNS servers provided for this interface
when the interface is the primary route.
Never: Never use DNS servers for this interface.
Local Area Networks (LANs)
for information
192