Table of Contents
Advertisement
Interfaces
If an authentication method is selected, type the Username and Password required to
authenticate the remote peer.
e. (Optional) Click to expand Custom PPP configuration.
f. Custom PPP configuration is disabled by default. Click toggle on Enable.
g. Enable Override to override the default configuration and use only the custom
configuration file.
h. For Configuration file, type or paste configuration data using the format of a pppd options
file.
14. (Optional) Click to expand 802.1x to configure 802.1x port based network access control.
The IX30 can function as an 802.1x authenticator; it does not function as an 802.1x supplicant.
a. Click to expand Authentication.
b. Click Enable server to enable the 802.1x authenticator on the IX30 device.
c. Set the Reauth period.
15. Configure IPv4 settings:
a. Click to expand IPv4.
IPv4 support is enabled by default.
b. Set the Metric.
c. For Weight, type the relative weight for default routes associated with this interface. For
multiple active interfaces with the same metric, Weight is used to load balance traffic to
the interfaces.
d. Set the Management priority. This determines which interface will have priority for
central management activity. The interface with the highest number will be used.
e. Set the MTU.
f. For Use DNS, select one of the following:
n
n
n
g. See
Configure SureLink active recovery to detect WAN/WWAN failures
about configuring SureLink for active recovery.
16. (Optional) Configure IPv6 settings:
a. Click to expand IPv6.
b. Enable IPv6 support.
c. Set the Metric.
d. For Weight, type the relative weight for default routes associated with this interface. For
multiple active interfaces with the same metric, Weight is used to load balance traffic to
the interfaces.
e. Set the Management priority. This determines which interface will have priority for
central management activity. The interface with the highest number will be used.
f. Set the MTU.
IX30 User Guide
Always: DNS will always be used for this WAN; when multiple interfaces have the
same DNS server, the interface with the lowest metric will be used for DNS
requests.
When primary default route: Only use the DNS servers provided for this interface
when the interface is the primary route.
Never: Never use DNS servers for this interface.
Local Area Networks (LANs)
for information
191
Advertisement
Table of Contents
