Table of Contents
Advertisement
Services
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > SNMP.
4. Click Enable.
5. Click Access control list to configure access control:
To limit access to specified IPv4 addresses and networks:
n
a. Click IPv4 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv4 address or network that can access the device's SNMP
d. Click again to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
a. Click IPv6 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv6 address or network that can access the device's SNMP
d. Click again to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the IX30 device:
n
a. Click Interfaces.
b. For Add Interface, click .
IX30 User Guide
agent. Allowed values are:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the SNMP agent.
l
agent. Allowed values are:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the SNMP agent.
l
Simple Network Management Protocol (SNMP)
525
Advertisement
Table of Contents
