Table of Contents
Advertisement
Virtual Private Networks (VPN)
12. Save the configuration and apply the change:
(config vpn openvpn client openvpn_client1 connection_monitor target 0)>
save
Configuration saved.
>
13. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
See
Show Surelink status and statistics
clients.
IX30 User Guide
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config vpn openvpn client openvpn_client1 surelink
target 0)> other_interface
ii. Set the interface. For example:
(config vpn openvpn client openvpn_client1 surelink
target 0)> other_interface /network/interface/eth1
(config vpn openvpn client openvpn_client1 surelink
target 0)>
o
Set the alternate interface's IP version. This allows you to determine the
alternate interface's status for a particular IP version.
(config vpn openvpn client openvpn_client1 surelink target
0)> other_ip_version value
(config vpn openvpn client openvpn_client1 surelink target
0)>
where value is one of: any, both, ipv4, or ipv6.
Set the expected status of the alternate interface:
o
(config vpn openvpn client openvpn_client1 surelink target
0)> other_status value
(config vpn openvpn client openvpn_client1 surelink target
0)>
where value is either up or down. For example, if other_status is set to
down, but the alternate interface is determined to be up, then this test will
fail.
for information about showing Surelink status for OpenVPN
OpenVPN
422
Advertisement
Table of Contents
