Verify Your Web Filtering Configuration - Digi IX30 User Manual

Firewall
d. Add the second DNS server:
i. Move back one node in the configuration tree:
(config firewall web-filter server 0)> ..
(config firewall web-filter server)>
ii. Add the server:
(config firewall web-filter server)> add end
(config firewall web-filter server 1)>
iii. Set the server's IP address:
(config firewall web-filter server 1)> ip 208.67.222.222
(config firewall web-filter server 0)>
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Verify your web filtering configuration

If your web filtering implementation has the service set to Cisco Umbrella, or if it is configured to use
manual DNS servers and uses the Cisco open DNS servers, you can verify the web filtering
implementation by using the Cisco test site www.internetbadguys.com.
To verify the implementation:

Web
This procedure assumes you have already configured web filtering to use either Cisco Umbrella or the
Cisco open DNS servers.
See Configure web filtering with Cisco Umbrella
n
with Cisco Umbrella.
See Configure web filtering with manual DNS servers
n
filtering to use Cisco open DNS servers.
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
IX30 User Guide
for information about configuring web filtering
for information about configuring web
Use Digi Remote Manager to view and manage your
Web filtering
801