Use An Automation To Start The Container - Digi IX30 User Manual

Containers
To verify by using the show containers command on the local device:
n
a. From the Remote Manager main menu, click  Management >  Devices.
b. Select the device.
c. From the Actions menu, select
d. At the prompt, type show containers.

Use an automation to start the container

You can also use an automation to start a container:
1. Follow the steps in the previous procedure, except:
For Run mode, select Manual.
n
Do not set Interval or Run single.
n
2. Create an automation
For the Command Line Message, use the
provided for the script in the previous procedure:
IX30 User Guide
iii. Type the device ID and press the Enter key.
iv. Click in the search text bar again and select Stream ID from the menu.
v. Type container and press the Enter key.
vi. Click the Stream ID to view container status.
that uses a Command Line Interface
Use Digi Remote Manager to deploy and run containers

Open Console.
step.
system script start command, using the label
808