Table of Contents
Advertisement
Interfaces
1. Log into the IX30 WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the
show network
> show network
Interface
----------------
defaultip
defaultlinklocal
eth1
eth1
eth2
eth2
loopback
modem
modem
>
3. Additional information can be displayed by using the
> show network verbose
Interface
Weight
----------------
----
defaultip
defaultlinklocal
eth1
eth1
eth2
eth2
loopback
modem
modem
>
4. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific WAN. For example, to display information about ETH1, enter show
network interface eth1:
IX30 User Guide
command at the Admin CLI prompt:
Proto
Status
Address
-----
-------
-------------------------------
IPv4
up
192.168.210.1/24
IPv4
up
169.254.100.100/16
IPv4
up
10.10.10.10/24
IPv6
up
fe00:2404::240:f4ff:fe80:120/64
IPv4
up
192.168.2.1/24
IPv6
up
fd00:2704::1/48
IPv4
up
127.0.0.1/8
IPv4
up
10.200.1.101/30
IPv6
down
Proto
Status
Type
-----
-------
------
IPv4
up
static
IPv4
up
static
IPv4
up
dhcp
IPv6
up
dhcp
IPv4
up
static
IPv6
up
static
IPv4
up
static
IPv4
up
modem
IPv6
down
modem
Wide Area Networks (WANs)
show network verbose
command:
Zone
Device
--------
--------
setup
eth2
setup
eth2
external
eth1
external
eth1
internal
eth2
internal
eth2
loopback
loopback
external
wwan1
external
wwan1
Metric
------
--
10
10
0
10
1
10
1
10
5
10
5
10
0
10
3
10
3
10
146
Advertisement
Table of Contents
