Table of Contents
Advertisement
Interfaces
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new LAN or edit an existing one:
To create a new LAN named my_lan:
n
(config)> add network interface my_lan
(config network interface my_lan)>
To edit an existing LAN named my_lan, change to the my_lan node in the configuration
n
schema:
(config)> network interface my_lan
(config network interface my_lan)>
4. Set the appropriate firewall zone:
(config network interface my_lan)> zone zone
(config network interface my_lan)>
See
Firewall configuration
5. Select an Ethernet device or a bridge. See
a. Enter device ? to view available devices and the proper syntax.
(config network interface my_lan)> device ?
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/loopback
/network/bridge/lan
/network/wireless/ap/digi_ap
Current value:
(config network interface my_lan)> device
b. Set the device for the LAN:
(config network interface my_lan)> device device
(config network interface my_lan)>
6. Configure IPv4 settings:
IPv4 support is enabled by default. To disable:
n
(config network interface my_lan)> ipv4 enable false
(config network interface my_lan)>
The LAN is configured by default to use a static IP address for its IPv4 configuration. To
n
configure the LAN to be a DHCP client, rather than using a static IP addres:
IX30 User Guide
for further information.
Bridging
for more information about bridging.
Local Area Networks (LANs)
155
Advertisement
Table of Contents
