Digi IX30 User Manual page 331

Routing
6. For Ping host, type my.devicecloud.com.
Task 5: Configure the DHCP server for ETH2 on device two
1. Click to expand Network > Interfaces > ETH2 > IPv4 > DHCP Server
2. For Lease range start, type 200.
3. For Lease range end, type 250.
4. Click Advanced settings.
5. For Gateway, select Custom.
6. For Custom gateway, enter 192.168.3.3.
7. Click Apply to save the configuration and apply the change.

Command line
Task 1: Configure VRRP on device two
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
IX30 User Guide
Virtual Router Redundancy Protocol (VRRP)
331