Table of Contents
Advertisement
Firewall
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Firewall > Zones.
4. In Add Zone, enter a name for the zone and click .
The firewall configuration window is displayed.
5. (Optional) If traffic on this zone will be forwarded from a private network to the internet,
enable Network Address Translation (NAT).
6. Click Apply to save the configuration and apply the change.
See
Configure the firewall zone for a network interface
network interfaces to use a zone.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
IX30 User Guide
Firewall configuration
for information about how to configure
762
Advertisement
Table of Contents
