Table of Contents
Advertisement
Services
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a geofence:
(config)> add service location geofence name
(config service location geofence name)>
where name is a name for the geofence. For example:
(config)> add service location geofence test_geofence
(config service location geofence test_geofence)>
The geofence is enabled by default. To disable:
(config service location geofence test_geofence)> enable false
(config service location geofence test_geofence)>
4. Set the amount of time that the geofence should wait between polling for updated location
data:
(config service location geofence test_geofence)> update_interval value
(config service location geofence test_geofence)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the format
number{w|d|h|m|s}.
For example, to set update_interval to ten minutes, enter either 10m or 600s:
(config service location geofence test_geofence)> update_interval 600s
(config service location geofence test_geofence)>
The default is 1m (one minute).
5. Set the boundary type for the geofence:
(config service location geofence test_geofence)> boundary value
(config service location geofence test_geofence)>
where value is either circular or polygonal.
If boundary is set to circular :
n
a. Set the latitude and longitude of the center point of the circle:
IX30 User Guide
(config service location geofence test_geofence)> center
latitude int
(config service location geofence test_geofence)> center
Location information
553
Advertisement
Table of Contents
