Digi IX30 User Manual page 316

Routing
Required configuration items
Both master and backup devices:
n
A configured and enabled instance of VRRP. See
l
Enable VRRP+.
l
WAN interfaces to be monitored by using VRRP+.
l
Note SureLink is enabled by default on all WAN interfaces, and should not be disabled on
the WAN interfaces that are being monitored by VRRP+.
If multiple WAN interfaces are being monitored on the same device, the VRRP priority will
be adjusted only if all WAN interfaces fail SureLink tests.
The amount that the VRRP priority will be modified when SureLink determines that the
l
VRRP interface is not functioning correctly.
Configure the VRRP interface's DHCP server to use a custom gateway that corresponds to
l
one of the VRRP virtual IP addresses.
Backup devices only:
n
Enable and configure SureLink on the VRRP interface.
l
Set the IP gateway to the IP address of the VRRP interface on the master device.
l
Additional configuration items
For backup VRRP devices, enable the ability to monitor the VRRP master, so that a backup
n
device can increase its priority when the master device fails SureLink tests.

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX30 User Guide
Virtual Router Redundancy Protocol (VRRP)
Configure VRRP
Use Digi Remote Manager to view and manage your
for information.
316