Table of Contents
Advertisement
Serial port
9. Click Finish to complete the installation process.
Configure RealPort on a Digi device from the Digi Navigator
You can configure the IX30 to communicate with your computer using RealPort from the Digi
Navigator. You must enable RealPort on the device and then configure your computer for RealPort.
In this step, all serial ports on the device are set to RealPort mode and the RealPort service is enabled.
The COM ports on your laptop are also configured.
Note
You can also manually configure the device for RealPort by logging into the device's web UI. See
Advanced RealPort configuration without using the Digi
1.
Download and install
2. Make sure the IX30 is powered connected your local network or computer with an Ethernet
cable.
3. Launch the Digi Navigator.
4. Specify the IP address of the Digi device:
To add a device, you will need the devices's IP address, and the user name and password
for the device.
i. Expand the Specify a device section.
ii. In the IP Address field, enter the IP address or host name for the device.
iii. Press Enter. A dialog displays.
iv. Enter the user name and password for the device in the User name and Password
fields.
v. Click Submit.
vi. The device you just added displays at the bottom of the Digi Navigator screen. You
can click Refresh to update the screen until the device appears.
5. Configure RealPort on the device.
IX30 User Guide
Configure RealPort mode using the Digi Navigator
the Digi Navigator.
Navigator.
254
Advertisement
Table of Contents
