Table of Contents
Advertisement
Serial port
iii. For Hostname, enter the host name or IP address of the remote site to which data
should be sent.
iv. For Port, enter the port number of the remote site to which data should be sent.
You can also configure access control for the serial port.
To do this, you need to go to Device Configuration:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
b. Access the configuration for the appropriate type of service:
i. Click to expand Serial.
ii. Click to expand the appropriate serial port.
iii. Click to expand UDP serial.
iv. Click to expand Access Control List.
IX30 User Guide
Configure UDP serial mode
241
Advertisement
Table of Contents
