Digi IX30 User Manual page 540

Services
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add service location source 1 acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to include additional firewall zones.
8. 1. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
2. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX30 User Guide
eth1
eth2
loopback
modem
(config)>
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
ETH1
ETH2
Loopback
Modem
Location information
540