Digi IX30 User Manual page 194

Interfaces
where value is one of:
n
n
n
f. See Configure SureLink active recovery to detect WAN/WWAN failures
about configuring SureLink for active recovery.
9. (Optional) Configure IPv6 settings:
a. Enable IPv6 support:
(config network interface ip_passthrough_interface)> ipv6 enable true
(config network interface ip_passthrough_interface)>
b. Generally, the default settings for IPv6 support are sufficient. You can view the default IPv6
settings by using the question mark (?):
(config network interface ip_passthrough_interface)> ipv6 ?
IPv6
Parameters
----------------------------------------------------------------------
---------
enable
metric
mgmt
mtu
use_dns
weight
(config network interface ip_passthrough_interface)>
c. Modify any of the remaining default settings as appropriate.
10. (Optional) To configure 802.1x port based network access control:
Note The IX30 can function as an 802.1x authenticator; it does not function as an 802.1x
supplicant.
a. Enable the 802.1x authenticator on the IX30 device:
(config network interface ip_passthrough_interface)> 802_1x
authentication enable true
(config network interface ip_passthrough_interface)>
IX30 User Guide
always: DNS will always be used for this WAN; when multiple interfaces have the
same DNS server, the interface with the lowest metric will be used for DNS
requests.
primary: Only use the DNS servers provided for this interface when the interface is
the primary route.
never: Never use DNS servers for this interface.
Current Value
true Enable
0 Metric
0 Management priority
1500 MTU
always Use DNS
10 Weight
Local Area Networks (LANs)
for information
194