Table of Contents
Advertisement
Serial port
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add serial port1 udp acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to include additional firewall zones.
IX30 User Guide
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
defaultlinklocal
eth1
eth2
loopback
modem
(config)>
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Configure UDP serial mode
Default IP
Default Link-local IP
ETH1
ETH2
Loopback
Modem
248
Advertisement
Table of Contents
