Digi IX30 User Manual page 193

Interfaces
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/loopback
/network/bridge/lan
/network/wireless/ap/digi_ap
Current value:
(config network interface ip_passthrough_interface)> device
b. Set the device for the interface:
(config network interface ip_passthrough_interface)> device device
(config network interface my_wan)>
7. Set passthrough options
8. Configure IPv4 settings:
IPv4 support is enabled by default. To disable:
n
(config network interface ip_passthrough_interface)> ipv4 enable
false
(config network interface ip_passthrough_interface)>
a. Set the IP metric:
(config network interface ip_passthrough_interface)> ipv4 metric num
(config network interface ip_passthrough_interface)>
b. Set the relative weight for default routes associated with this interface. For multiple active
interfaces with the same metric, the weight is used to load balance traffic to the interfaces.
(config network interface ip_passthrough_interface)> ipv4 weight num
(config network interface ip_passthrough_interface)>
c. Set the management priority. This determines which interface will have priority for central
management activity. The interface with the highest number will be used.
(config network interface ip_passthrough_interface)> ipv4 mgmt num
(config network interface ip_passthrough_interface)>
d. Set the MTU:
(config network interface ip_passthrough_interface)> ipv4 mtu num
(config network interface ip_passthrough_interface)>
e. Configure how to use DNS:
(config network interface ip_passthrough_interface)> ipv4 use_dns
value
(config network interface ip_passthrough_interface)>
IX30 User Guide
Local Area Networks (LANs)
193