Table of Contents
Advertisement
Routing
4. Click Enable.
The default firewall zone setting, Dynamic routes, is specifically designed to work with routing
services and should be left as the default.
5. Configure the routing services that will be used:
a. Click to expand a routing service.
b. Enable the routing service.
c. Complete the configuration of the routing service.
6. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable routing services:
(config)> network route service enable true
(config)>
4. Configure routing services that will be used:
a. Use the ? to display available routing services:
(config)> network route service ?
Routing services: Settings for dynamic routing services and protocols.
Parameters
---------------------------------------------------------------------
----------
enable
zone
Additional Configuration
---------------------------------------------------------------------
IX30 User Guide
Current Value
true
Enable
dynamic_routes
Zone
IP routing
303
Advertisement
Table of Contents
