Digi IX30 User Manual page 120

Interfaces
Manual—The device will only connect to the carrier identified in the Network PLMN ID.
n
If the carrier is not available, no cellular connection will be established.
Manual/Automatic—The device will attempt to connect to the carrier identified in the
n
Network PLMN ID. If the carrier is not available, the device will fall back to using
automatic carrier selection.
5. If Manual or Manual/Automatic are selected for Carrier section mode, enter the Network
PLMN ID.
Note You can use the
and determine their PLMN ID. See
6. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX30
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, type:
(config)> network interface modem modem operator_mode value
(config)>
where value is one of:
automatic—The device automatically selects the carrier based on your SIM and cellular
n
network status.
manual—The device will only connect to the carrier identified in the Network PLMN ID.
n
If the carrier is not available, no cellular connection will be established.
IX30 User Guide
modem scan command at the Admin CLI to scan for available carriers
Scan for available cellular carriers
Wide Area Networks (WANs)
for details.
120