Table of Contents
Advertisement
Services
5. Set the type of location source to server:
(config service location source 0)> type server
(config service location source 0)>
6. Set the UDP port that will receive incoming location messages.
(config service location source 0)> server port port
(config service location source 0)>
7. Click Access control list to configure access control:
To limit access to specified IPv4 addresses and networks:
n
(config)> add service location source 1 acl address end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add service location source 1 acl address6 end value
(config)>
Where value can be:
l
l
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the IX30 device:
n
(config)> add service location source 1 acl interface end value
(config)>
Where value is an interface defined on your device.
IX30 User Guide
A single IP address or host name.
A network designation in CIDR notation, for example, 192.168.1.0/24.
any: No limit to IPv4 addresses that can access the location server UDP port.
A single IP address or host name.
A network designation in CIDR notation, for example, 2001:db8::/48.
any: No limit to IPv6 addresses that can access the location server UDP port.
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
defaultlinklocal
Default IP
Default Link-local IP
Location information
539
Advertisement
Table of Contents
