Table of Contents
Advertisement
G6 Crop Cruiser Series 2 Operators Manual - Software Update Supplement
Engine & Drivetrain Information
Updated G-Hub Home screen (refer Series 2 Manual page 73).
G-Hub Software Update
The information in this booklet is provided as a
supplement to the existing:
•
G6 Crop Cruiser Series 2 Operators
Manual - GA8701177 Revision 2
•
G6 Crop Cruiser MY20 Operators
Manual - GA8701602 Revision 00
- with the new G-Hub software release.
Settings - Service - Software screen showing the new software release installed (refer Series 2 Manual page 54).
4
Sprayer Operation
Menu
The information provided in this supplement
must be read fully and understood by the
operator prior to driving or operating the
machine post installation of new G-hub
software versions:
-
G-Hub Cabin Display
1.2.0.1
-
G-Hub External Display
2.2.0.1
-
PLC
3.2.0.1
The Hand Throttle can be used with Classic, Variable or 2
Speed Cruise Control modes.
New Throttle Controls
A new 'Hand Throttle' engine speed control
provides additional controls for the existing
3 Cruise Control modes (Classic, Variable &
2 Speed) of the Crop Cruiser, as well as the
addition of a 4th mode called, 'Joystick Target
Speed'.
These allow the Crop Cruiser to be driven
using the Hand Throttle or foot throttle.
Press the Cruise Control touch button to open the Cruise
Control Mode selection screen.
Hand Throttle
The new Hand Throttle mode, featured in the
software update, complements the existing
foot throttle operation.
The Hand Throttle can be used in Neutral,
Forward & Reverse (just like the foot throttle)
and in conjunction with the foot throttle.
The Hand Throttle is On by default. However,
it can only be used when the Cruise Master is
turned Off.
If the foot throttle is used while the Hand
Throttle control is active, the Hand Throttle will
be temporally disabled while the foot throttle
controls engine speed.
After the foot throttle is released, the target
engine rpm automatically transfers back to
Hand Throttle control.
If the Hand Throttle is in the 'Neutral Gate' position when
starting-up the Crop Cruiser, then Hand Throttle must be
moved forward and back into the 'Neutral Gate' to arm
(activate) it.
GA8701177 REV 2 SUPPLEMENT SEPT 2022
Advertisement
Table of Contents
