Autosteer System - Connectors - Goldacres Crop Cruiser G6 Operator's Manual

Autosteer System - Connectors

Inside the power distribution box are electrical
connectors that have been provided for the
connection of optional Autosteer equipment.
GPS REMOTE SWITCH MOMENTARY +12V
For the connection of the G-Motion GPS
momentary switch from the joystick mounted on
the side dash. When this single pin connector is
connected to the ISOBUS based cabin harness it
will be able to communicate directly with the John
Deere Autosteer node. To make use of this button
circuit for Trimble based Autosteer systems, it should
be connected independently on the cabin harness
and directly to the Trimble harness instead.
GPS REMOTE SWITCH
For the connection to an auto steer system. The
cable has a 3 pin male weather pack plug for the
customer to connect their Auto steer system. The
switch is labelled Road mode/spray mode and is
located on the side dash. When this 3 pin connector
is connected to the ISOBUS based cabin harness it
will be able to communicate directly with the John
Deere Autosteer node. To make use of this button
circuit for Trimble based Autosteer systems, it should
be connected independently on the cabin harness
and directly to the Trimble harness instead.
SEAT SAFETY SWITCH
The seat safety switch or operator presence switch
causes the Autosteer system to turn off when the
operator leaves their seat as a safety measure.
The harness part numbered GA3000147
incorporates a connector for the seat safety switch.
This connector is able to communicate directly with
the John Deere Autosteer node. This connector
(male) on harness GA3000147 will be joined to the
CLAAS cabin seat harness safety switch connector
(female) when John Deere Autosteer is fitted. The
seat safety switch can be optionally connected for
Trimble based Autosteer systems. To do so, the seat
connector should be joined direclty to the Trimble
harness and independently of harness GA3000147.
This way the trimble node will be able to receive the
signal from the seat safety switch.
32 - Chapter 4 - Cabin
Above: GPS resume - remote switch momentary
+12V circuit.
Above: GPS master - remote switch circuit.
Seat compressor
Seat safety switch
Above: Safety switch harness from back of CLAAS
seat.
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
To CLAAS seat
Continued over page